Zymol HD-Cleanse Pre Wax Cleaner 250ml

Description:

Zymol recommend that you HD cleanse your cars paintwork to remove any previous wax or sealents that are already on the paintwork with Zymol HD-Cleanse for the first time, otherwise the Zymol wax will not bond to your paint surface properly.

A very, important first step in protecting your car's finish prior to first time application of Zymol wax and for maintaining the lustre throughout the life of ownership.

Zymol HD-Cleanse will remove any dead, oxidized paint, light oxidization, moderate scratches, accumulated road film, light tar and acid rain deposits.

Zymol HD-Cleanse renews your original paint lustre without the use of harsh chemicals or stripping back paint.

Available in now only a 250ml bottle.

Features:

No harsh chemicals, therefore does not strip microns of paint to achieve the result.

Montan Oils essential to reviving the paints original jetness of colour even on new paintwork from the factory.

Excellent in the repair of swirl marks, light oxidization and light scratches/scuffs.

Helps to break down road film, light tar and acid rain deposits.

Breaks down the chemicals from previous products used.

Ingredients:

Contains Montan Oil, Apricot Kernel Oil, Lemon Seed Oil, Coconut Oil, Cetyl Esters, Cetyl Cocomide (derived from coconut oil), Cocoamide, Citric Acid (from rose hips), Kapolite.

Directions for use:

Directions for Use:

1. Apply a small amount of HD Cleanse to a Pre-Wax Applicator.
2. Lightly rub using a back-and-forth motion to cover an area about two feet by two feet.
3. Allow the product to sit on the paint surface for about 30 seconds and then rub it with the applicator. Work over the area for about three to five passes.
4. Take a towel, folded into a pad and wipe over the area until it is clean. If the HD Cleanse starts to harden, use distilled water in a Schpritzer bottle. Mist over the area, then wipe, using a dry, clean towel. Wipe until all the HD Cleanse has been removed.

Now, how do you know when the surface is really clean? Apply HD Cleanse with the pre-wax applicator in a straight line, side-to-side pattern over a two-foot by two- foot area. Let it stand for about 20 seconds, then buff with light pressure.

Buff the area until the paint is clean, and then re-apply to half the cleaned area, using the same procedure. Is there a difference? Go back over the entire area twice more, and then split the panel again. Stand back ten feet and look for a difference in colour and depth. If it looks good, the number of times you had to rework this area is the number of times the panels have to be done. This usually applies to all horizontal surfaces.

Very Important: Do not drive the car or allow it to stand more than 24 hours without completing the zymol process.