Last's for upto 3 years
**Use your Powerdrill**
Flexipads SWIRL FREE Mitt
**HALF PRICE!! OFFER**
Aqua Gleam Car Wash Water Filter 0ppm
SPECIAL OFFER!! 4x FREE MICROFIBRE POLISHING CLOTHS OFFER!! Spend over £59 and receive 4x Microfibre Polishing Cloths* excludes postage* POSTAGE OFFER!! Only £3.95 for any parcel upto 30kgs* Normally £6.95 UK Zone 1 only*
Spend over £59 and receive 4x Microfibre Polishing Cloths* excludes postage*
POSTAGE OFFER!! Only £3.95 for any parcel upto 30kgs* Normally £6.95 UK Zone 1 only*
Description:This amazing aqua gleam car wash 0ppm spot free car rinse water filter works wonders on leaving your car after rinsing totally spot free by removing impurities in the water that normally leave spot marks and streaks.
This water filter is very easy to use with no hassle, just simply clip on to your garden wall tap with the hose fittings and away you go.
The length of time the resin will effective for will depend on a few factors the water hardness of your area where you live 'see map' and the length of time spent rinising your car down with it connected to the filter.
* Length 350mm (13.7")
* Width 100mm (4")
Please Note: This filer comes complete with two hose end connectors only.
Features:No watermarks or streaks
No need to chamois dry car down
Complete with two hose lock end fittings.
Rinse and just walk away
Touchless drying = less swirl marks on your paintwork
Spot free results after rinsing
Lots of other uses: eg: motorbikes, boats, aircraft, motorhomes, hard to reach exterior windows and glass conservatories.
Directions for use:1) Wash your vehicle in the normal way using warm soapy water applied with a sponge or wash mitt. Rinse the soapy water away using normal tap water directly from your hose. Keep the rinsed areas wet while you complete the whole vehicle.
Please Note: Do not allow the vehicle to dry before you rinse a second time using treated water through the filter.
2) Connect the filter to your hose using the connectors supplied. Rinse the whole vehicle a second time.
3) Stand back and allow to air dry naturally for a spot free result.
Do not use in conjunction with a pressure washer
Use water from the filter sparingly.
Only use enough water to re-wet all surfaces
Keep using the filter until you are no longer satisfied with the results. Dispose in normal non recyclable waste bin when no longer giving the desired results.
Store filter in a dark place when not in use.
The 0ppm filter is for use in soft water areas and the 30ppm is for use in hard water areas see the map below, the 0ppm filter gets the best finish in hard or soft areas but will run out much quicker in a hard area thats where the 30ppm comes into play. The 30ppm will last longer but the finish is not as high as the 0ppm.
UK Water Hardness Map
England and Wales
This map shows the levels of hardness tends to increase the further south east you go. Most of Devon and Cornwall in the south, North Yorkshire and Cumbria in the north and the western counties of Wales have soft to moderately soft water. Northumberland, Tyne & Wear and Lancashire down through the Midlands tend to have slightly hard to moderately hard water. Lincolnshire, the Home Counties and the south east have hard to to very hard water.
The majority of Scotland has soft to moderately soft levels of hardness, although some areas have levels of varying hardness.
North - soft to moderately soft
East - soft to slightly hard
South - soft to very hard
West - soft to moderately hard
Predicted Filter Life
Approximately ten litres of purified water should be sufficient to rinse an average four door saloon car.
These figures are intended as guidelines only. Factors that reduce filter life include, hard water sources, use from a water softener (due to added salt content) and water from bore holes.