Monza Price £39.99
FEYNLAB® Plastic reformulates the faded dull oxidized surface into a deep rich looking finish that also grants a new chemical structure which protects from UV rays and future fading.
Once Plastic is Fully Cured, it is recommended to top with Universal for UV protection.
Durability, Warranty, & Application Surfaces
Warranty Duration – 1 yr.
Application includes 1 component layer, reaching an overall film build between 1-2 microns.
APPROVED SURFACES FOR APPLICATION ONLY: – DO NOT apply to unapproved surfaces
Included:
30ml (1oz) FEYNLAB® Plastic
Cautions:
Always wear respirator & gloves during application. Ensure application area is free of loose contamination.
Surface Preparation
Thoroughly clean vehicle using FEYNLAB® PURE WASH vehicle to remove all topical contamination. Follow with a topical decontamination clay treatment using FEYNLAB® PRIME.
Directions
Prior to application place vehicle in a well lit, temperature controlled 10°C-30°C (50°F-85°F), & contamination
free environment.
Shake PLASTIC vigorously for 1 min before use.
Application Instructions:
Note: The amount of Plastic required will vary based upon the overall type of plastic and the starting condition. More oxidized faded plastics may require more product for restoration. For extremely faded plastic use FEYNLAB®PLASTIC BLACK.
Inspect
Be sure to carefully inspect all finished panels for any leftover coating residue (high spots) during the final wipe. Commonly edges, emblems, and other tight areas may contain some remaining residue. High spots are much easier to remove if caught within a 20-40 min window after the final wipe, than later when the coating has set and curing has started.
Post Application Instructions
Climate Notes
All FEYNLAB® Coatings are subject to different dwell and curing time windows due to humidity and temperature. In General, the higher the humidity level the quicker the coating will cure. If humidity level approaches 80% or higher then consider lessening the recommended dwell and wipe times for the coating.
If possible apply coating in temperature controlled environment 10°C-30°C (50°F-85°F), with humidity as low as possible.
Reviews
There are no reviews yet.